Polytree TGC0P4693C01 Assembly Instructions

TREE ASSEMBLY INSTRUCTIONS

Congratulations on purchasing your new tree from
and Simple Shape technology -Set up and light up your tree in less than 10 minutes! Carefully follow the
instructions below on how to quickly and easily set up your new tree.
1. Before you start to assemble your tree, choose an appropriate location near a wall outlet.
2. Assemble the tree stand and place on a level surface. (See Fig. A)
Fig. A -
Tree Stand Assembly
Eye Bolt
Fig. B - Tree and Light Assembly
Section 5
Section 4
Section 3
Section 2
Section 1
3. Each tree section is numbered with a tag. Please identify all sections before assembling.
4. Assemble the tree from bottom to tree top. Start with the section 1 and remove protective cap before
inserting into the assembled stand. Make sure the pole is firmly inserted and secured into the stand.
5. Continue by inserting the upper tree section(s) to the lower section(s) until inserting the tree top.
6. Insert the remote controller into the wall outlet.(see Fig. B ), your entire tree should now be lit. If some
bulbs do not light or flickers, search for any loose plugs and/or broken, loose or missing bulbs.
Connecting the plugs or replace the bad bulbs promptly in order to maintain the performance and life
expectancy of your pre-lit tree.
7. Allow branches to fall into place or gently pull up and out. When adjusting branches, be sure that all
wires are free of branch hinges.
8. This tree is constructed with Quick Set® and Simple Shape technology. Shaping is not necessary; you
just need to slightly upsweep all branch tips for a uniform look (see Fig.C) and shift branches to fill any
gaps. Your Christmas tree is now ready to be decorated.
Fig. C
Top view
MODEL #: TGC0P4693C01
Polytree®!
This tree assmebles with Quick Set®
Eye Bolt 1. Pull apart the legs of the stand so that
they are snapped into an x-shape, place the
tree stand on a level surface.
2. When inserting the bottom section of the tree
into the assembled stand, insert and turn the
Click
eyebolts into the stand and tighten until the
tree pole is firmly secured.
To close the stand, remove the eyebolts, press
the metal button and fold the legs together.
Do Not Tamper
Internal Parts
Open the
protective
cover
Fig.F
Timer
Insert the adaptor into the timer, insert the timer
Foot Pedal
into the extension cord, and insert the extension
cord plug into remote controller. Then insert the
on/off Switch
remote controller into the wall outlet.
Side view
*Electrical Rating For The Tree
(For Indoor Use Only)
6.6A 120V 60Hz
Remote Controller
Extension Cord
On
Off