Cleaning And Maintenance; Replacing The Line Spool; Waste Disposal; Ordering Replacement Parts - Einhell Royal RT 5030 Manual

Anleitung RT 5030_SPK1:_
GB
Never use the grass trimmer without the guard.
Do not mow grass when it is wet. The best
results are achieved with dry grass.
Connect the power cable to the extension cable
and attach it in the handle (Fig. 9).
To switch on your grass trimmer, press the
safety ON/OFF switch (Fig. 1/Item 3).
To switch off your grass trimmer, let go of the
ON/OFF switch (Fig. 1/Item 3).
Do not allow the grass trimmer near the grass
until the switch is pressed, i.e. the grass trimmer
is in operation.
To cut properly, swing the machine sideways
while moving forwards. Keep the grass trimmer
inclined at an angle of approx. 30° while you do
so (see Figs. 10 and 11).
If the grass is long, the grass must be cut shorter
in stages, starting from the tip (see Fig. 12).
Use the edge guide and the guard hood to
prevent unnecessary wear on the line.
To avoid unnecessary wear on the line, keep the
grass trimmer away from hard objects.
9. Using the grass trimmer as an edge
trimmer
To cut he edges of lawns and flower beds, the grass
trimmer can be converted as follows:
Switch off the power supply of the grass trimmer.
Release the lock (6) completely and turn the top
handle (2) 180° to the right.
Retighten the lock (6).
Now you have converted the grass trimmer to an
edge trimmer, for cutting the lawn vertically (Fig.
13).

10. Replacing the line spool

Important. Make sure that you pull out the
power plug before exchanging the line spool!
Press the sides of the spool cover as shown and
remove the cover (Figure 14).
Remove the empty line spool.
Thread the ends of the line on the new line spool
through the eyelets in the spool cover (Fig. 15)
and allow approx. 10 cm of line to project.
Fit the spool cover and spool back into the spool
mounting.
When you start the machine again the line will be
cut to the perfect length automatically.
14
05.12.2006 15:25 Uhr Seite 14
Important. Bits of the nylon line could cause
injury when being flung out.
Integrated in the additional handle is a holder for the
additional line spool. To remove the line spool,
squeeze the two catches slightly (Fig. 16).

11. Cleaning and maintenance

Switch off and unplug the grass trimmer before
putting it away or cleaning it.
Remove deposits from the guard hood with a
brush.
Clean the plastic body and plastic parts with a
mild household detergent and a damp cloth.
Never use aggressive agents or solvents for
cleaning purposes!
Never spray down the grass trimmer with water.
Prevent water getting into the trimmer at all cost.
12. Faults
The machine does not work: Check that the
power cable is connected properly and check the
mains fuses. If the machine will not work in spite
of the voltage supply being OK, please send it to
the specified after-sales service address.

13. Waste disposal

Please note
The grass trimmer and its accessories are made
of various types of material such as metal and
plastic.
Defective components must be disposed of as
special waste.
Ask your dealer or your local council.

14. Ordering replacement parts

Please quote the following data when ordering
replacement parts:
Type of machine
Article number of the machine
Identification number of the machine
Replacement part number of the part
required
For our latest prices and information please go to
www.isc-gmbh.info
Spare line spool Art. No.: 34.050.50