Tamron M13VG850IR Owner's Manual page 2

TM13VG-E-U-1206
Thank you very much for purchasing our CCTV lens.
In order to understand the lens specifications and performances, please read this manual thoroughly and handle the lens with care.
MOUNT-TYPE
CS mount is equipped with Tamron CCTV lens. Before you use the lens, please make sure that the mount type matches that on your camera.
INSTALLATION ON CAMERA
The lens can be installed by screwing it clockwise into CS-mount on the CCTV camera. Once the lens is screwed in completely to its mechanical stop position, you will then be able to rotate
lens chassis back to suit the set-up position of the camera.
WIRING DIAGRAM
Please read the user's manual for the devices such as the camera and controller before wiring. Then please follow the chart below to insure the right connection.
Supplied with 4-Pin Square Connector (JEITA Standards) 1— —Control (-) 2— —Control ( + ) 3— —Drive ( + ) 4— —Drive (-)
IRIS
If the camera has a selection switch between Video and DC, please set it to DC.
TO INSURE LONG TERM USE
(1) Please remove dust on the lens by using a blower or soft brush. Avoid touching the lens surface directly with fingers.
(2) In order to remove finger prints or oil stains on the lens surface, use lens cleaning paper or clean cotton cloth with a little cleaning liquid. Then, wipe off the stains lightly starting from
the center of the lens surface. Please wipe the lens body with a silicon cloth. Avoid using any organic solvents such as thinner or benzene.
SPECIFICATION
MODEL
Imager Size
Focal Length
Aperture Range Auto Iris
Angle of View
Filter Size
Mount-Type
DC Auto Iris
TAMRON PRODUCT SAFETY PRECAUTIONS
The follwing symbols are used in these precautionary statements.
This symbol warns that an electrical current
is present and electric shock may occur.
Shock !
These precautionary statements are classified into two levels of danger depending on the content and grade of elements that comprise the product.
If the user does not obey these instructions and misuses the product, serious injury or
Warning !
loss of life may occur.
Don't disassemble the unit or try to put any foreign substance in it, especially metal or
flammable matter. Doing so could cause electric shock and/ or fire.
Please keep the unit away from water. If water should get inside the unit, stop using
immediately, otherwise electric shock and/ or fire may occur.
Don't place the unit near extreme heat, flame or gas since combustion may occur
resulting in fire.
Don't scratch, open, twist or heat the connector cable because doing so many cause
fire and/ or electric shock.
If the user does not obey these instructions and misuses the product, serious injury
Caution !
and/ or property damage may occur.
Don't place the product in locations with extremely high or low temperatures. Don't use the product
in areas that are hotter than 60 degress Centigrade or colder than -10 degrees Centigrade.
Such extremes will effect the quality performance of the product and could damage it.
Don't point the lens directly at the sun or other strong light since that could damage the image
sensor on the camera and result in poor image quality.
Don't drop or hit the product forcefully. This may cause product performance failure.
Don't place the connector cable next to a heater since it could melt and cause fire and/
or electric shock.
Don't plug in or pull out the cable to or from an electrical outlet with wet hands. This may
result in electric shock.
TAMRON CO.,LTD. Industrial Optics Unit
1385 Hasunuma, Minuma-ku, Saitama-shi, Saitama 337-8556 JAPAN Tel: +81-48-684-9129 Fax: +81-48-683-8594 http://www.tamron.co.jp
CCTV/ IP LENS OWNER'S MANUAL
 When adding plus voltage to Drive (+), will move to the opening direction.
Horizontal
Vertical
Resistance of Drive coil
Resistance of Control coil
Max Voltage
For safe operation, be sure to carefully read the manual and the following cautions before using. After reading them,
store them in a place where they can easily be reviewed whenever needed.
This is a fire hazard symbol that means there
is the possibility of igniting fire.
Fire !
M13VG850IR
CS mount
M13VG850IR
M13VG850IR
M13VG850IR
1/3"
8-50mm
1.6-360
(TELE) 5.6º
(TELE) 4.2º
— —
CS-Mount
M13VG850IR
190 ± 10% (20ºC)
700 ± 10% (20ºC)
6V
Specifications are subject to change without notice.
represents prohibition.
The mark inside represents the action.
This symbol means that you should not
Do not !
disassemble the product.
If the connector cable is cracked or damaged, please exchange it by writing to Tamron with an
exchange request. If you continue to use the damaged cable, fire and/ or electric shock may result.
Don't try to repair the unit or any power source since that may cause fire and/ or
electric shock.
Don't attempt to use product if you suspect something isn't right as in seeing smoke or detecting a
strange smell. If you use the product under these conditions fire and/ or electric shock could occur.
Don't look through the lens directly at the sun since this could cause blindness.
Keep the product out of the reach of children. If the product fell on a child, injury could occur.
When attaching the lens to the camera body, make sure you grip it securely to avoid the
possibility of the lens falling.
When storeing the lens, keep it out of direct sunlight. Fire could occur as a result of the
light being reflected off the lens onto a flammable substance.
Don't place in dusty and humid place. Fire and/ or electric shock may occur.
Don't place the product near a stove or humidifier or any place where there is high heat
or moisture. Fire and/ or electric shock may occur.
If you are going to connect the product with aonther product, please read the connection
instructions from product manuals carefully before attempting any connection.
Otherwise damage may result to one or both products.
If you are going to use a lens that has a tripod mount but are using a camera body that is
heavier than the lens, please use the tripod mount on the camera.
Failure to do so could result in severe damage to the lens.
(WIDE) 33.5º
(WIDE) 25.1º
represents instraction.
The mark inside represents the action.
This symbol means that you should pay
Direction !
attention to certain handling procedures.