Table of Contents
Advertisement
7. Drill the handle attachment holes for the fasteners through the frame
(from step 3).
8. Remove the clamps (and/or tape)
9. Attach your handle using flat head or truss head bolts.
10. Re-install the rubber gasket by pressing it into the slot making sure it is evenly seated
and flat.
11. Reassemble the door back onto the hinges.
The door hinge stop is set at 110 .
Whille the door is off, you can
change it to either 90 or 140 .
Simply change the position of
the stop screw in the lower hinge
plate as shown.
If the door requires adjustment,
the top and bottom hinge each
have adjustmet screws.
Loosen the screws,
then with the door open,
raise the handle side to level
and re-tighten the screws.
o
o
o
12
ADJUSTMENT SCREWS
TOP
BOTTOM
Advertisement
Table of Contents
