Checking The Filters In The Wash Cabinet; Cleaning The Filters - Miele G 7100C Operating Instructions Manual

Checking the filters in the
wash cabinet
The filter combination in the base of the
wash cabinet retains coarse soiling
from the suds solution. This prevents
soiling getting into the circulation
system and re-entering the wash
cabinet through the spray arms.

Damage due to soiling entering
the circulation system.
Without filters, soiling can enter the
circulation system and cause a
blockage.
Do not run a wash programme
without the lower spray arm or
without the filters.
When cleaning the filters and spray
arms, make sure that coarse soiling
cannot get into the circulation
system.
The filters can become blocked by
soiling that collects over time. The level
of soiling and the time it takes before
the filters need cleaning will vary
depending on use.
The message Check filters
the display after every 50 programme
cycles.
 Check the filter combination.
 Clean it, if necessary.
 Then confirm the message with OK.
will appear in
Cleaning and care

Cleaning the filters

 Switch the dishwasher off.
 Remove the lower spray arm (see
"Cleaning and care" chapter,
"Cleaning the spray arms" section).
 Before removing the filter
combination, remove any coarse
soiling to prevent it from entering the
circulation system.
 Remove the filter combination.
65