3rd Power Kitchen Sink 6VEL User Manual page 14

Back Panel: Foot Switch System (continued)
FS B
OPERATION NOTES:
The remote foot-switch allows you to put the KITCHEN SINK's 6VEL advanced features under foot
control. The unit includes a high quality 15' 7-Pin DIN cable with a straight plug for the back of the
amp and a right angle plug for use at the pedal. The amplifier provides phantom power through the
cable to drive the LEDs.
• To prepare your KITCHEN SINK for channel switching operation, select FTSW via the mini toggle
switch on the front panel of the amp adjacent to the input jack. You may now remotely control
your channel change function.
• +GAIN (ch. 2 only): Select FTSW on the +GAIN mini toggle switch located in between the Gain
and Volume control of channel two on the front panel of the amplifier. You may now remotely
control your channel extra gain function.
• Hybrid-MASTER Bypass (Boost): The Hybrid-Master bypass is permanently connected to the FS
Bus circuit. Should you wish to disable the boost, simply turn the Bypass control to zero (fully
counter-clockwise). When setting up this feature, start with the Bypass control on zero. Dial in
the perfect rhythm volume via the Hybrid-Master control (start with a setting of 11 o' c lock), and
then engage the HM Bypass feature on the foot switch. Slowly turn the HM Bypass control
clockwise until the perfect lead volume is achieved. Now you can toggle back and forth for a
rhythm preset and a lead boosted preset.
• FX Loop On/Off: On the back panel of the amp, place the mini toggle switch in the FTSW
position. This assigns the loop on/off to the FS Bus. With both +Gain and FX Loop assigned, an
excellent lead solo preset is created where additional gain and sustain come from the preamp,
any effect (such as digital delay) engages, and the volume increases to your specified preset
level - all with the stomp of a single button on your foot switch.
WARNING:
The Kitchen Sink 6VEL foot switching system cannot share an electrical ground with any other
device. Care should be used when placing your 2 or 4 Button foot switch with other devices on a
pedal board or metal tray so as to keep the unit isolated from metal to metal connection.
14