Subscribe to Our Youtube Channel
Related Manuals for Endura FasTrack
Summary of Contents for Endura FasTrack
- Page 1 Instruction Manual Air Powered Racking Machine Endura Corporation www.enduraracking.com • E-mail: enduracorp@verizon.net 510 Church Street • Nokomis, FL 34275 US • Phone:(941) 488-8277 • Fax:(941) 488-7383...
- Page 2 Any problems with the safety circuit should be reported to Endura Corporation immediately so the system can be properly repaired prior to bringing the machine back into production.
- Page 3 By Endura Corporation PREPERATION INSTRUCTIONS (Figure 1) (Figure 2) (Figure 3) (Figure 4) HOOK UP - Hook up a clean, dry air supply to the pressure regulator. (Figure 1) - Pressure regulator is set at 80 lbs. PREPARATION PROCEDURE - Insert rack in rack holders on each side of machine.
- Page 4 By Endura Corporation OPERATING PROCEDURE (Figure 1) (Figure 2) (Figure 3) (Figure 4) OPERATING PROCEDURE 1. Insert rack into rack holders at each end of the machine. (Figure 1) 2. Depress both palm buttons simultaneously and hold. Rear jaw and rack moves forward.
- Page 5 By Endura Corporation UN-RACKING PROCEDURE (Figure 1) (Figure 2) (Figure 3) (Figure 4) UNRACKING PROCEDURE 1. Place rack in holders on top of the fixed jaw of the machine. (Figure 1 & 4) 2. Depress both palm buttons. When parts drop off, engage the release lever.
- Page 6 By Endura Corporation MAINTENANCE (Figure 1) (Figure 2) (Figure 3) (Figure 4) MAINTENANCE • Periodically lubricate the 3/4" shaft and linear bearings. (Figure 1) • DO NOT LUBRICATE THE SMALLER SHAFT (1/4"). THIS IS A FRICTION DRIVE, AND LUBRICATION WILL DEFEAT THE FUNCTION.
Need help?
Do you have a question about the FasTrack and is the answer not in the manual?
Questions and answers