Endura Ultimate Trilennium Installation Instructions

Compatible astragal shoot bolt

Endura Ultimate

Trilennium

Astragal Shoot Bolt

Installation Instructions

Note: This kit includes an upper or lower shoot bolt. If you are replacing the lower shoot bolt, you will also need to

replace the corner pad on the shoot bolt. For maximum performance, we recommend that you use the Endura Simple

Solution™ Corner Pad.

STEP 1: REMOVE DOOR PANEL FROM JAMB

To replace the shoot bolt, you will need to remove the inactive door panel off the frame. We recommend you use

assistance for this step .

Remove the inactive door panel by loosening and removing screws from the hinges.

Place the panel vertically against a strong support to gain easy access to the

astragal.

SKU:BD-INST-ETCA-BOLT

Revised:10-12-2016

Compatible

Tools and Supplies:

• Phillips Screw Driver

• Pliers

8817 West Market Street, Colfax, NC 27235

800.334.2006 Fax: 336.668.4478

www.enduraproducts.com

Table of Contents

Do you have a question about the Ultimate Trilennium and is the answer not in the manual?

Page 1 Note: This kit includes an upper or lower shoot bolt. If you are replacing the lower shoot bolt, you will also need to replace the corner pad on the shoot bolt. For maximum performance, we recommend that you use the Endura Simple Solution™...
Page 2 STEP 2: REMOVE COMPONENTS FROM ASTRAGAL a. Remove the trim strip along the b. Unscrew and remove c. Unscrew the strike plate and entire astragal body. Note where the the bolt sleeves off the top remove. 5 pieces of the strip belong, as you and bottom bolts to reveal will have to return them to the exact additional securing screws.
Page 3 STEP 4: RETURN COMPONENTS INTO ASTRAGAL a. Return the shoot bolt so its engagement b. Replace the spine assembly in the exact location head notches securely in to the grooves on the it was removed from. Confirm correct installation by metal driver rods.
Page 4 STEP 5: RETURN COMPONENTS AND REINSTALL DOOR PANEL a. Return bolt sleeves. Ensure that in the disengaged or b. Return the trim strip on the door in the same unlocked state, the end of the bolt is flush with the end of locations that they originally were.