Advertisement
Quick Links
K&A Manufacturing
6703 Zinser Street
Schofield, WI 54476
Phone: 800.298.4351
Fax: 866.882.9475
www.raproducts.com
7/14/17
Series 4 HV Double Monitor
Lift Assembly Instructions
Read all the instructions before beginning.
Instruction # 53375
Hardware Pack # 53369
Page1 OF 8
Advertisement
Related Manuals for RightAngle 4 HV Series
Summary of Contents for RightAngle 4 HV Series
- Page 1 K&A Manufacturing 6703 Zinser Street Schofield, WI 54476 Phone: 800.298.4351 Fax: 866.882.9475 www.raproducts.com 7/14/17 Series 4 HV Double Monitor Lift Assembly Instructions Read all the instructions before beginning. Instruction # 53375 Hardware Pack # 53369 Page1 OF 8...
- Page 2 Tools Required for Assembly: Power Driver W/Adjustable Torque #2 Phillips Head Driver Bit Phillips Screwdriver 3/16" Hex Head Driver Bit or K&A Manufacturing Allen Wrench 6703 Zinser Street Schofield, WI 54476 Phone: 800.298.4351 Level Fax: 866.882.9475 www.raproducts.com Square Tape Measure 51687 50133 51708...
- Page 3 Step 2: Using a power driver and a #2 phillips head driver bit, drive (24) slim fix bolts 1 into the back panel 3 , the kick panel 4 , and the worksurface 7 ; K&A Manufacturing (8) in each panel. 6703 Zinser Street Schofield, WI 54476 Phone: 800.298.4351 Fax: 866.882.9475...
-
Page 4: Bottom Bracket
K&A Manufacturing 6703 Zinser Street Schofield, WI 54476 Phone: 800.298.4351 Fax: 866.882.9475 www.raproducts.com Step 4: Lay the column assemblies 8 on the back panel 3 as shown below. Step 5: Attach the bottom bracket of the column assemblies 8 to the back panel 3 by screwing (8) machine screws 12 through the back of each bottom plate and into the inserts in the back panel Do not fully tighten. - Page 5 Step 9: Lay the left leg assembly 10 on a protected surface with the threaded screw holes facing up. Attach the left side panel 5 to the left leg assembly with (3) machine screws 14 . The longer edge of the K&A Manufacturing 6703 Zinser Street Schofield, WI 54476 side panel must face the back of the leg assembly.
- Page 6 Step 13: If your unit has power options, see Sheet 8. Insert the (8) slim fix bolts 1 in the kick panel 4 into the connector cams 2 pre-installed in the left side panel 5 and the right side panel 6 . You may need to K&A Manufacturing move the side panels slightly to align the bolts with the 6703 Zinser Street Schofield, WI 54476...
- Page 7 Step 18: Insert (4) grommet inserts 17 into the holes in the kick panel 4 . To operate the grommets, disassemble the rotating inserts from the flange. Align one of the slots K&A Manufacturing 6703 Zinser Street Schofield, WI 54476 in the inner insert with the slot in the outer insert.
Need help?
Do you have a question about the 4 HV Series and is the answer not in the manual?
Questions and answers