Keithley KPCI-3110 User Manual page 74

3-14 Installation and Configuration
NOTE It is recommended that you connect all unused analog input channels to
analog ground.
This section describes how to connect single-ended, pseudo-differential, and differential voltage
inputs, as well as current loop inputs to the STP-3110 screw terminal panel.
Connecting single-ended voltage inputs
Figure 3-5 shows how to connect single-ended voltage inputs (channels 0, 1, and 8, in this case)
to the STP-3110 screw terminal panel.
Figure 3-5
Connecting single-ended voltage inputs (shown for Channels 0, 1, and 8)
Signal Source
- +
Vsource 0
Analog In 0
Analog In 8
- +
Analog In 1
Vsource 8
-
+
Vsource 1
KPCI-3110 and KPCI-3116 User's Manual
STP-3110 Panel
TB33
TB34
TB1
TB2
TB3
Analog Ground
Jumper W1 Installed
(Amp Low)
W1