Automatic Drain Operation; Timer Operation; Timer Controls - Wolf Steamer Use & Care Information Manual

W O L F
A U TO M AT I C D R A I N
IMPORTANT NOTE: The steamer module
must be installed with a drain connection and
access to the drain through the base cabinet.
The
only while the unit is in Idle mode. The unit
must be unlocked and not in operation. Refer
to the illustration below.
To activate the drain:
1) Touch
beep, the light in the
illuminate and the drain valve will open for
a period of 2 minutes. This should be
enough time to drain a full capacity of
water. This operation may be repeated as
many times as needed to completely drain
the steamer basin.
2) Touch
mode operation to shut the drain valve. The
light in the
If you do not have a fixed drain connec-
tion, use caution when draining hot water
from the steamer basin to avoid burns.
Use a heat-resistant receptacle with a
minimum 7.6 L capacity. The doors of the
base cabinet must be locked.
12
S T E A M E R M O D U L E U S E & C A R E
O P E R A T I O N
touch pad operation is functional
for 3 seconds. The unit will
touch pad will
again while in the drain
touch pad will go out.
Touch control panel
T I M E R O P E R A T I O N
The control panel of the steamer module has
an independent 99-minute timer. Refer to the
illustration below. This function can be used
with or without the unit in operation. However,
the steamer must not be in Lock mode.
To start the timer, touch the "+" or "–"
symbol until the correct amount of time is
shown in the timer display. The timer will
begin its countdown after a 2 second delay.
A warning beep will sound when the timer
has 1 minute left and begins to countdown
in seconds starting at 59.
A signal will beep when time has expired
and will continue to beep every 30 seconds.
Touch
touch pad
touch pad
to reset the timer.
"+" and "–"
symbols
Timer
display

Timer controls