Configuration; Overview - Siemens SENTRON 3WL10 Manual

Configuration

4.1

Overview

Installation
Information about installation of the necessary components is to be found in the relevant
operating instructions. You will find more information on this in chapter Reference
documents (Page 6).
Reading and writing parameters
It is always possible to read parameters with the powerconfig software (front interface or
fieldbus interface), irrespective of whether the switch is set to "Local bus ON" (local) or
"Local bus OFF" (remote).
For writing parameters and switching, the switch must be set to "Local" or "Remote".
Changing the setting
⇒ with the ETU display of the circuit breaker (
ON/OFF
If the circuit breaker is set to "Local bus ON" (local):
● Writing and switching parameters can only be performed via the front interface via
TD410 / TD420.
● Parameters cannot be written or switched via the fieldbus interface (Modbus TCP or
Modbus RTU). An error message is displayed in powerconfig.
If the circuit breaker is set to "Local bus OFF" (remote):
● Writing and switching parameters can only be performed via the fieldbus interface.
● Parameters cannot be written via the front interface of the circuit breaker and the
TD410 / TD420. An error message is displayed in powerconfig.
See also
Commissioning communication modules (Page 26)
Industry online support (https://support.industry.siemens.com/)
System Manual, 04/2020, L1V30499596021-02
)
Display → Settings → Modules → Local bus →
4
29