Bartell Global B424 Owner's Manual page 13

WALK-BEHIND TROWELS
OWNER'S MANUAL
Fig. 4
Step 3: Install pitch control
cable to yoke and install
locknut loosely (Fig. 4). If
needed, turn pitch control knob
counter-clockwise until the
stop screw is at the lowest
position (Fig. 5).
Fig. 7
Step 5: Unwrap throttle control and engine safety
shut-off wires to prepare for their assembly. (Fig. 7
and 8)
Fig. 10
Step 7: Check for free moving
engine throttle control lever
and loosen pivot nut if
necessary (Fig. 10)
Fig. 5
Step 4: Lift and install handle to position using the supplied four sets of
lockwashers and nuts. Do not torque greater than 18ft-lb. At the yoke;
tighten the locknut for pitch control cable (Fig. 6). If the cable is too loose or
tight, the pitch control range position can be moved by changing the
position of the stop screw (Fig. 5). The factory default is the middle position.
Turn the pitch control knob completely clockwise and check for maximum
pitch possible. This is possible when the clearance between the yoke and
underside of the gearbox is enough to pass a business card through.
Fig. 8
Fig. 11
Step 8: Push handle throttle lever
all the way forward for idle position
(Fig. 11). If necessary, the tension
screw can be adjusted for smooth
operation while holding throttle
position.
13
Fig. 6
Fig. 9
Step 6: Remove air filter cover and
air filter. (Fig. 9)
Fig. 12
Step 9: Install the throttle
control wire into the throttle
control lever. (Fig. 12)
OI – B19001