Table of Contents
Advertisement
WALK-BEHIND TROWELS
OWNER'S MANUAL
ASSEMBLY INSTRUCTIONS (B424, B430 EDGER)
Folding handle version: Your new Bartell Edger Power Trowel has been shipped to you fully
assembled. All you need to do is remove the locking pin, unfold the handle and re-insert the
locking pin.
Rigid handle version:
Remove any shipping or packing materials. On Euro models, be sure to remove and discard
the band securing the safety/stop switch on the handles. This serves only to facilitate shipping
and is not intended to be a permanent feature.
When removing the machine from the carton, be careful to use the handles to lift the unit from
the carton. NEVER LIFT THE MACHINE BY THE RING OR DISC. Filling the fuel tank and a
brief check of lubricant levels in preparation for operation is required.
ASSEMBLY INSTRUCTIONS (BC436, BC446, B436, B446, MEGA-T)
Your new Bartell Walk-Behind Power Trowel has been shipped to you partially assembled.
Filling the fuel tank and a brief check of lubricant levels in preparation for operation is required.
IMPORTANT: Before running machine, ensure that engine idles properly and that the
safety-switch shuts off the engine.
To complete the assembly for all Bartell Walk-Behind trowels, the following instructions will be
helpful.
Fig. 1
Step 1: Trowel shown with handle
separate. (Fig. 1)
Fig. 2
Step 2: Lay handle on ring to prepare for assembly. (Fig. 2 and 3)
12
Fig. 3
OI – B19001
Advertisement
Table of Contents
