Bosch TS2000 Operating/Safety Instructions Manual page 6

For Mounting Bosch 4000
Table Saw to Stand
1. Using the diagram below, locate the Bosch
4000 mounting holes and position saw on
stand as shown in figure F.
2. Place one (1) 6 mm flat washer onto one
(1) 6 mm x 75 mm hex head bolt and insert
bolt through mounting hole in table saw
and through stand table top.
3. Place one (1) 6 mm flat washer and
securely tighten with one (1) 6 mm lock
nut.
Repeat this procedure on the three remaining
mounting holes.
For Mounting Other Table Saws
Important: Before mounting a DeWalt,
Craftsman, Makita, Hitachi, or Ridgid table
saw, insert two (2) 8mm x 50mm Phillips
head screws through "B*" hole locations and
tighten using 8mm lock nuts.
1. Using the diagram below, locate the
correct mounting holes for the table saw
being used and position saw on stand
accordingly.
For use with Hitachi Table Saw:
If your TS2000 stand does not have "H"
holes, you will need to drill holes. Place
the saw over the center of the opening and
make pencil marks (through the L-shaped
bracket holes) on the table top mounting
plates. Remove saw and drill four (4) 5/16"
diameter holes through the mounting
plates.
For use with Ridgid Table Saw:
Locate the four "R" holes in the two
mounting plates and drill four (4) 3/8"
diameter holes completely through the
stand's frame.
2. Mount the table saw using the appropriate
mounting hardware for your table saw
model.
Assembly
Table Saw Models
Bosch 4000
Dewalt DW744
Craftsman 21830
Makita 2703
Hitachi C10RA2**
Ridgid TS2400LS**
-6-
Mounting
Holes
**See instructions.
FIG. F
B
D
C
M
H
R