Table of Contents
Advertisement
Using your Soundbar
Let's get started
2. On the device that you would like to connect
to your Soundbar via Bluetooth (e.g. TV/iPhone/
iPad/Android/other phone/Tablet/Computer), turn
on Bluetooth connectivity and ensure that it is
'discoverable' .
Note: If necessary, refer to the instructions for your
device to add or set up Bluetooth.
3. When found, your Soundbar will be displayed as
'ALBA Soundbar' . Select the device name to begin
pairing.
Note: If your device requests a password, please
enter '0000' to complete the device pairing.
4. When pairing is complete a tone will sound and the
blue LED will change to be continuously on (not
flashing).
Note: After approximately 60 seconds the blue
LED will turn off. You can press any button on the
remote control, to turn the LED back on again.
5. Now that you have paired your device with the
Soundbar, it will connect to it when it is within
range, which is about 10 metres or less (33 feet or
less), line of sight.
6. Your device will remain paired with the Soundbar
unless you decide to disconnect or 'unpair' it.
Note: You can press and hold the Pair button on the
end of the Soundbar to unpair your current device
and search for new devices.
Controlling a paired device
Once paired you can either use the controls on the
connected audio device to play/pause, skip tracks etc.,
or you can you the control buttons on the Soundbar
remote control.
Play/Pause
Press and release to skip forward
Press and release to skip back
or online at www.argos-support.co.uk If you still require further assistance, call one of our experts on 0345 600 3021.
Line in mode
Check that your Soundbar is in Line in mode.(Green
LED). If you are not already in Line in mode, press and
release the Source button on the Soundbar or the Line
in button on the remote control to go to Line in mode.
The Green LED behind the front speaker mesh will turn
on to indicate this.
1. Connect one end of a 3.5mm audio cable (not
supplied) to the headphone (or auxiliary out) socket
of your secondary device.
2. Connect the other end to the Line in socket on the
end of your Soundbar.
3. Press the Play button on your external device to
start playback through the Soundbar.
4. To gain optimal volume levels, adjust the volume
level on both the secondary device and on the
Soundbar.
Note: It is recommended that you unplug the audio
cable from the Line in socket on the end of the
Soundbar, after you have finished listening to your
external device.
Optical input mode
Check that your Soundbar is in Optical input mode
(Orange LED). If you are not already in Optical input
mode, press and release the Source button on the
Soundbar or the Optical button on the remote control
to go to Optical input mode. The orange LED behind
the front speaker mesh will turn on to indicate this.
1. Connect one end of an optical audio cable (not
supplied) to the optical out socket on your TV. .
2. Connect the other end of the cable to the optical
input socket on the back of your Soundbar. Make
sure that it is aligned correctly and that it is pushed
firmly home into the socket.
3. The optical sound output from your TV, will now be
via your Soundbar.
Standard features
17
Advertisement
Table of Contents
