Table of Contents
Advertisement
Using your Soundbar
Let's get started
Power on
Press and release the Power button on the end of the
product or on the remote control. Your Soundbar will
switch on in Bluetooth mode. The blue LED behind
the front speaker mesh (on the far right hand side) will
flash quickly whilst your product searches for Bluetooth
devices.
Standby mode
Press and hold the Power button on the end of the
product or on the remote control. Your Soundbar will
go to Standby mode. The red standby LED behind the
front speaker mesh will turn on.
Note: This product is designed to go to
STANDBY mode automatically after 15 MINUTES
(approximately), if it does not receive an audio signal.
Press and release the Power button on the end of
the Soundbar or on the remote control to switch
your product back on again.
Change the mode
Press and release the Source button on the end of the
Soundbar or the individual source buttons (Bluetooth/
Line in/Optical/Aux) on the remote control to change
between Bluetooth, Line in Optical and Aux modes.
The LEDs behind the front speaker mesh will turn on to
indicate the current mode.
Red LED:
Standby
Green LED:
Line in
Orange LED:
Optical input
White LED:
Aux (Left and Right RCA connection)
Blue LED:
Bluetooth
Note: Approximately 60 seconds after you have
selected the mode (Bluetooth/Line in/Optical/Aux),
the LED indicator will turn off. When you press a
function button on the remote control, the LED will
turn back on again.
If you require any technical guidance or find that your product is not operating as intended, a simple solution can often be found in the Troubleshooting section of these instructions,
16
Standard features
Adjusting the volume
Vol- (on the soundbar)
Volume- (on the remote)
• Press and release to decrease the volume in steps.
• Press and hold to progressively decrease the
volume.
Vol+ (on the soundbar)
Volume+ (on the remote)
• Press and release to increase the volume in steps.
• Press and hold to progressively increase the volume.
Bass or Treble enhancement
The Bass and Treble settings each range from -5 to +5.
1. Press and release the Bass or Treble + or - button
on the remote control to adjust the Bass or Treble
as appropriate.
Note: The Bass and Treble will have no effect when
you are using the EQ 'Movie' setting.
Equaliser (EQ)
There are 3 EQ settings available on your Soundbar.
These are Music*, Movie and Dialog.
* Music is the default setting and your Soundbar will be
set to this when you first use your product.
1. Press and release the relevant 'Music' . 'Movie'
or 'Dialog' EQ button on the remote control, as
required.
Pairing with a Bluetooth device
Before you can use your Soundbar in Bluetooth mode
with your TV or other Bluetooth capable device, you
need to 'pair' it.
1. When you first power on your Soundbar or when
you change the mode to Bluetooth, the blue LED
on the front of the product will flash quickly whilst
your product searches for Bluetooth devices.
Advertisement
Table of Contents
