WARNING: Do not use the product with a
damaged spark plug cap to prevent
electrical shock.
Note: To start the product when the engine is warm, it is
not necessary to use the choke control.
To stop the product
•
Move the stop switch to the stop position to stop the
engine.
CAUTION: The stop switch automatically
goes back to run position.
To operate the product
•
Start near the ground and move the product up
along the hedge when you cut the sides.
Introduction
WARNING: Read and understand the safety
chapter before you do maintenance on the
product.
Maintenance schedule
Maintenance
Clean the external surface.
10
•
Adjust the speed to align with the work load.
•
Make sure that the engine does not touch the hedge.
•
Hold the product near your body for a stable work
position.
•
Make sure that the tip of the cutting equipment does
not touch the ground.
•
Be careful and work slowly until all the branches are
correctly cut.
Maintenance
Before
After 40
operation
h
After each operation.
1118 - 001 - 05.09.2019
After 100
h