ECR 4 Kids ELR-008-B Manual

San Diego, CA 92110 USA
www.ecr4kids.com
Adjustable Art Easel
Model# ELR-008-B
WARNING:
Adult Assembly Required.
Two adults recommended.
- Contains small parts, sharp points and edges.
- Do not stand, sit, kneel, climb, lean or pull on
unit for support.
- Never leave children unattended.
- Do not place unit near high heat or moisture.
- Adult supervision recommended.
TOOLS INCLUDED
Hex Tool (1)

Parts List

BEFORE ASSEMBLING, MAKE
SURE YOU HAVE ALL THE PARTS
Chalk Board (1)
A
B Dry Erase Board (1)
Batch ID Sticker
located on backside
C Trays (2)
D
Easel Legs (2)
E Hex Screws & Plastic Nuts (8/8)
E1 E2
Use the Hex Tool
F
Clips (4)
1

Install the Dry Erase Board

Open an Easel Leg (D) completely and secure the hinge into the locked position. Place onto a
protective surface with the locked hinge facing down.
Install the Dry Erase Board (B) onto Easel Leg (D) with two Hex Screws & Plastic Nuts (E1/E2)
as shown.
Reminder: Do not overtighten,
as the plastic threads can be
stripped.
Note: The height of the
board/tray can be adjusted by
installing into upper/lower sets
of holes on the Easel Legs.
Carefully rotate onto the
Dry Erase Board (B) on
a protective surface.
2

Install the Chalk Board and Tray

Open the other Easel Leg (D) completely and secure the hinge into the locked position.
Install the Chalk Board (A) onto both Easel Legs (D) with four Hex Screws & Plastic Nuts (E1/E2).
Align a Tray (C) behind the Chalk Board (A) before tightening the lower hex screws and plastic nuts.
Tip: Install the upper Hex Screws & Plastic Nuts first.
Reminder: Do not overtighten,
as the plastic threads can be
stripped.
Carefully rotate upright.
Batch ID Sticker
See Next Page