Table of Contents
Advertisement
9.
CONNECTION OF MOTOR CORD
CAUTION
・ Before connecting to the Motor Cord to the Brushless Motor Spindle and CONTROLLER, verify
the Main Power Switch on the CONTROLLER is turned OFF. If the Main Power Switch on the
CONTROLLER is ON while connecting the Motor Cord, damage to the CONTROLLER is possible.
・ Install the Protective Cap etc. to prevent damage or contamination to the Motor Cord Plug when
not in use.
① Remove the Protective Cap of the Motor Cord.
② Carefully insert the alignment pin into the alignment hole and push straight into the Connector of the Motor Cord.
Brushless Motor Spindle Side
③ Tighten the Connector Nut with clockwise.
④ Remove the protective air inlet Quick Disconnect
Cover.
⑤ Insert the provided air hose.
10.
INSTALLATION OF THE BRUSHLESS MOTOR SPINDLE
WARNING
When installing a Brushless Motor Spindle to a ¿xed base, make sure the ¿xed base is grounded in
order to avoid the risk of an electric shock.
Alignment Pin
Connector
Take Out
Alignment Hole
Connector
Fig. 9
Connector Nut
Brushless Motor Spindle Side
Take Out
Protective Cap
Fig. 8
Motor Cord Side
Tighten
Motor Cord Side
Fig. 10
Push
Fig. 11
Insert
Fig. 12
7
Advertisement
Table of Contents
