Panasonic NP-6R2MUQNZ Operating And Installation Instructions page 22

Using the Dishwasher
Adding Dishware during Operation
Dishware can be added at any time before the Detergent Dispenser opens.
1. Press the Pause/Start button to stop the Dishwasher.
2. Open the Dishwasher door and add the dishware.
3. Close the Dishwasher door. Then, press the Pause/Start button. The Dishwasher will
run after approximately 10 seconds.
At the End of the Wash Cycle
When the working cycle has fi nished, the buzzer of the Dishwasher will sound 8 times
before stopping.
Switch OFF the Dishwasher
The Programme indicator turns OFF when the programme has ended.
1. Switch OFF the Dishwasher by pressing the OFF/ON button.
2. Turn OFF the water tap.
3. Switch OFF the main switch on the wall.
Open the door carefully
1. Hot dishware is sensitive to breakage. The dishware should therefore be allowed to
cool down for approximately 15 minutes before removing from the Dishwasher.
2. Slightly open the Dishwasher door and wait for approximately 15 minutes before
removing the dishware. The dishware will be cooler and improve drying.
Unloading the Dishware
It is normal that the Dishwasher is wet inside. Empty the Lower Basket fi rst and then the
Upper Basket. This will avoid water dripping from the Upper Basket onto the dishware in
the Lower Basket.
Do not open the door when washing, hot water or steam may scald the user.
Wait for approximately 15 minutes before unloading the dishes to avoid
handling them while they are hot and susceptible to breakage.
22
WARNING