Panasonic NP-6R2MUQNZ Operating And Installation Instructions page 15

Using the Dishwasher
1
1. To add rinse aid, remove the Cap by turning it (anti-clockwise)
2. Pour the rinse aid into the dispenser; be careful not to overfi ll.
3. Refi t the Cap and close it by turning (clockwise) so that the arrows line up.
■
Note:
Clean up any rinse aid spilled while during fi lling with an absorbent cloth to avoid
excessive foaming during the next wash. Do not forget to replace the Cap before closing
the Dishwasher door.
Adjusting Rinse Aid Dispenser
The Rinse Aid Dispenser has six settings which can be
viewed upon removing the cap. Always start with the
dispenser set on "4". If still facing spots and poor drying
problem, increase the amount of rinse aid dispensing
by rotating the dial to "5". If the dishes are still not
drying properly or spots remain, adjust the dial to the
next higher level until the dishes are spot-free. The
recommended setting is "4". (Default value is "4".)
■
Note:
Increase the dose if there are drops of water or lime spots on the dishware after
washing. Reduce it if there are sticky whitish stains on dishware or a bluish fi lm on
glassware or knife blades.
2 3
Rinse Aid
Adjust Level
15