Operation - Omcan LAR-15PMB Instruction Manual

Discharging Procedures
To discharge processed product from Blender Models proceed as follows:
1. Turn machine OFF.
2. Remove Lid Nº01 (Pic. 01).
3. Press Lock Pedal Nº07 (Pic. 01) down.
4. Tilt Cup Nº02 (Pic. 01) holding its handle and discharge processed product as needed.
Cleaning
The new Blenders cup has stamped ribs that facilitate cleaning. Wash the Lid Nº01 and the Cup Nº02 (Pic. 01)
with water and neutral soap. Wipe up the other parts with a damp cloth.
IMPORTANT: Never do cleaning with machine plugged in. Always unplug machine before cleaning.
When washing inside the Cup be careful with the blade.
Maintenance
Danger
Any maintenance with the machine in working situation is dangerous. TURN IT OFF BY PULLING THE PLUG
OFF THE SOCKET DURING MAINTENANCE.
IMPORTANT: Always unplug the machine when emergency cases arise.
Advice
Electrical or mechanical maintenance must be done by qualified personal for such operation. Person in charge
has to be sure that the machine is under TOTAL SAFETY conditions when working.
Routine Inspection - Unplug Machine
Advice
When checking the tension of the belts or chains, DO NOT introduce your fingers between the belts and the
pulleys and nor between the chain and the gears.
Precautions
Check if motors and sliding or turning parts of the machine produce abnormal noises. Check the tension of the
belts and chains and replace the set when belt or chain show signs of being worn out. When checking tensions
of belts or chain DO NOT introduce your fingers between belts and pulleys, nor between the chains and gears.
Check protections and safety devices to make sure they are working properly.
Maintenance
7

Operation