Advertisement
GIRA
Smoke detector
Info
Instructions for Installation
Minimum protection: one smoke detector in
the hallway or in the stairwell of each floor
Optimum protection: one smoke detector in
each bedroom and living room
Installation and commissioning
Smoke detector
Connection block
Socket
Spacers
Smoke detector
Plug
Screw
Battery (9V)
Test button
45/00
Unsuitable installation sites
In order to prevent false alarms and
malfunctions, do not install the smoke detector:
•
in rooms where a large amount of steam,
dust, or smoke are produced under normal
circumstances.
•
near hearths and open fireplaces.
•
near ventilation shafts, since the stream of
air could possibly prevent smoke from
reaching the detector.
•
near fluorescent and energy-saving lamps,
since the starter can trigger false alarms
due to the electrical fields caused by
turning the lamp on (minimum distance:
50 cm).
•
in rooms where temperatures are below
+5°C or above +45°C.
Remove the two spacers from the socket.
Otherwise, locking of the smoke detector is
not possible.
1. Install the socket
installation material.
2. Use the spacers
, if the linking line of
several smoke detectors is "surface-
mounted".
3. If needed, carry out the appropriate steps to
link several smoke detectors.
For this, read the chapter "Linking smoke
detectors".
4. Connect the 9V block battery
connection and insert the battery into battery
bracket.
5. Stick the smoke detector
and lock it by turning slightly clockwise.
Caution: If no battery is inserted, the smoke
detector cannot be fixed in the socket.
6. Carry out a function test.
with the included
to the battery
into the socket
Seite: 2 von 5
Advertisement
