J) Select Operating Mode ("Auto", "Manu", "Cancel"); K) Switching Feedback - Renkforce 1391580 Operating Instructions Manual

j) Select operating mode ("AUTO", "MANU", "CANCEL")

If the temperature controller is not in a setting mode, you can briefly push
the button "FUNC" to select the operating mode.
Operating mode "AUTO"
The temperature controller automatically maintains the temperature ac-
cording to the setting of the times/weekdays in the 8 programmes "PROG1"
to "PROG8".
Operating mode "MANU"
The temperature controller maintains the temperature for the duration of 24
hours after activation of the operating mode; then it will return to automatic
mode.
Operating mode "CANCEL"
The temperature controller is deactivated; there will be no switching.

k) Switching Feedback

The special feature of the RS2W radio switching system, which the temper-
ature controller and the enclosed receiver (radio switching socket) belong
to, is that there is a feedback on the successful (or unsuccessful) switching
process.
The receiver reports receipt and execution of switching back to the trans-
mitter. This way, you will always be able to see whether the radio receiver
(e.g. a radio switching socket) has performed the control command or not.
For the temperature controller, the display uses the double arrows:
" " Switching process successful, feedback received
" " No feedback from the receiver received
Reasons for missing feedback may be interferences on the same
frequency, detrimental reception conditions or similar (see the fol-
lowing chapter 9) or the receiver may not be connected to the mains
voltage.
45