Lightmaxx VEGA SILENT PAR Series User Manual page 13

Notice! (Power supply)
It is essential that you check that the device voltage matches your local mains
voltage. It is highly recommended that you fuse your mains socket with a residual
current circuit breaker (FI).
If you do not use your device for a longer period of time or carry out maintenance
work, disconnect the device from the mains in order to minimize danger. The same
applies to storm conditions such as thunderstorms, floods, etc.
Warning! (Error during data transmission)
Never connect the DMX input or output to audio devices such as power amplifiers or
mixing consoles!
DMX cables enable trouble-free operation and the highest possible transmission
reliability of signal data. Do not use microphone cables!
Warning! (For babies and children)
Dispose of or store any packaging material properly! Packaging material must be
kept out of the reach of babies and children due to the risk of suffocation.
Ensure that children never use the appliance unattended! In addition, make sure
that children do not remove (small) parts from the device, as they could suffocate by
swallowing parts!
Installation:
Be sure to check the device for damage before use. Use original packaging or suitable transport or
storage packaging to protect the product properly against dust or moisture, etc.
The device can be installed for standing or hanging. The attachment is always should be placed on a
solid, approved carrier or a corresponding surface. In order to mount the device, use the opening of
the bracket. Always provide a second, independent fuse of the device, e.g. through a safety.
Working on the equipment (such as assembly) should always take place on a stable platform. Make
sure the area below you is fixed in place.
Please note that it is not possible to use this device with a dimmer!
Warning! (Risk of injury due to falling down)
Improper installation can cause considerable injury and damage!
The installation of the device should always be carried out by experienced person
nel and must be carried out in compliance with the mechanical and electrical safety
regulations in your country.