Advertisement
6
STEP 6. Turn the workbench upside down and screw in the corner braces (O) as shown in the diagram. At each corner attach the leg levellers (T).
Slide the workbench top (P) under the main unit and fix with 4 hex head screws (U).
6 7
STEP 7. Attach the inner slides onto the drawers. Slot the horizontal
tab into the hole in the drawer and the vertical tab into the
other hole. Push down until the stop slots into the small hole.
8
STEP 8. Pull the middle slide and the ball bearings out as far as
possible. Hold the drawer and slot the inner slide on the
drawer into the middle slide, then push the drawer all the
way in.
To remove drawer see Step 2.
AP2050BB - 1 - 260407
Advertisement
