Quoizel RO9018AC Installation Manual

Please go to www.quoizel.com
Tools Required: Flathead screwdriver, Phillips screwdriver, pliers, wire cutters, wire strippers, electrical tape, safety glasses,
drill bit, center punch, hammer, drill and wrench.
Light Source: (1) A21 Medium Base Bulb 150W Maximum, Medium Base Vintage Bulb is recommended, bulb not included.
Estimated Assembly Time:
Preparation: Identify and inspect all parts before beginning installation. Check package content list and diagrams below to ensure all parts are
present. If any parts are missing or damaged, do not attempt to assemble, install, or operate the fixture. Contact your original place of purchase.
Warnings and Cautions
Turn off electricity at circuit breaker or main fuse box before installation. Consult a licensed electrician if in doubt.
These instructions are provided for your safety. It is very important you read them completely before installing the fixture. We strongly
recommend that a licensed, professional electrician perform the installation.
Disconnect fixture from power source before replacing bulbs. Make sure bulbs are given sufficient time to cool before removal.
Package Contents
Mounting Screw
A
x 3
Side Rod
B
x 2
Lock Ball
C
x 4
-
STEP 1 Remove Papers Inside of the Cage
A. Rotate the bolt and remove it from the bolt holder to open the door.
B. Remove papers inside of the cage.
C. Close the door and place the bolt back onto the bolt holder.
Bolt Holder
2018 QuoizelInc.
for product cleaning tips. Go to the
20-30 minutes
D
E
Paper
(Remove)
Door
Figure 1
visit us on-line at www.quoizel.com
Installation Guide #IS-RO9018AC
For Style RO9018AC
Care + Maintenance selection.
-
STEP 2 Install Arm and Side Rods
A. Place tabs on the ends of the Arm (D) over bolts on the Fixture
Arm
Body (E) and secure with Lock Balls (C). Hand tighten until snug.
x 1
B. Thread Side Rods (B) onto the Fixture Body (E) and hand tighten
until snug.
Fixture Body
Tab
x 1
Bolt
STEP 3 - Mark the Location for the 3 Mounting Holes
A. Place the light fixture onto the post and mark the location of the 3
mounting holes on the fixture fitter onto the post with the marking
pen.
Bolt
Fixture
Fitter
Post
1of2
marking pen, 1/16"
D
C
E
Figure 2
Post
Lighting
Marking Pen
Mounting
Hole
Figure 3
ReleasedDate:2018-09-13
B
Fixture
Fitter
Post