Download Print this page

Advertisement

Quick Links

50" Kyte

Advertisement

loading
Need help?

Need help?

Do you have a question about the Kyte 50 and is the answer not in the manual?

Questions and answers

Summary of Contents for Kichler Lighting Kyte 50

  • Page 1 50” Kyte...
  • Page 3: Wall Control

    WALL CONTROL 50” Kyte...
  • Page 5 A. Ceiling Bracket Assembly H. Package Hardware: B. Canopy Assembly 1) Mounting Hardware: wood screws (2), C. Motor Assembly flat washers (2), screws (2), D. Blade Assembly (2) lockwashers (2), wire connectors (3) E. Shorter Blade Arm (2) 2) Safety Cable Hardware: wood screw F.
  • Page 7 Outlet Box Ceiling Bracket Assembly Flat Washer Screw Fig. 5 Step 2. Remove the screw near by the round dot label and remain it for later use. Loosen the other two screws without fully removing them. (Fig. 6) Screw Fig. 6 50”...
  • Page 8 Screw Step 3. Firstly choose the blade arm (part E or part F) what your want. Slide the blade arms through slots in motor assembly and attach to the hub using the screws provided. Make sure the screws securing the blade arms to the hub are tight and are properly seated.
  • Page 9 Step 5. Hang the canopy assembly to the hook on the ceiling Ceiling Bracket Assembly Canopy Assembly bracket assembly as shown. You can now proceed with electrical Hook wiring of your fan. (Fig. 9) Fig. 9 Flat Washer Wood Screw Support Brace Spring Washer Ceiling...
  • Page 10 Safety Cable Bolt Wood Screw Step 1. Set the slide switch in the OFF (-) position. (Fig. 12)
  • Page 11 BLACK (TO POWER SUPPLY) BLACK BLACK Step 3. Connect the green grounding lead from the ceiling bracket (To FAN) to the supply grounding, from fan and from wall control conductor (this may be a bare wire or wire with green colored insulation). Securely WHITE (NEUTRAL) WHITE GROUND...
  • Page 12 Screw Ceiling Mounting Bracket Motor Assembly Step 1. Hold the motor assembly and release it from the hook on the ceiling mounting bracket. Position the round holes near the round dot label on the motor assembly and ceiling mounting bracket directly. Lift up the motor assembly, allowing the two ceiling bracket screws to slide into the mating slots.
  • Page 13 Step 3. Attach the blade assembly to the blade arms and tighten screws provided. (Fig. 15) NOTE: Hold up the middle area of the blade assembly by your hand (see the figure); Do not loosen your hand prior to completing the installation. Motor Assembly Screw Blade Assembly...
  • Page 14 Fig. 16 Wall Outlet Box Wall Control Wall Plate Fig. 17...
  • Page 15 1. The slider is used to set each fan speed separately. Speed Move it up or down to select the desired speed. (Fig. 18) 1 = High Speed Fan O 2 = Medium High Speed 3 = Medium Speed 4 = Low Speed - = Fan O Fig.
  • Page 17 following modifications installation. radiate radio television reception, 50” Kyte...