Operation; Front And Rear Panels; Preparations - Korg DS-DAC-10R Owner's Manual

Front and rear panels

Indicator
Headphone volume Knob

Preparations

When driver installation is completed, use a USB cable to connect the DS-DAC-10R to your
computer, and make preparations for listening to an audio file on your computer.
After connecting the USB cable and until the DS-DAC-10R's system setup has completed,
the indicator alternately blinks green and blue.
When the indicator changes to being steadily lit, start AudioGate.
Use the included USB cable to connect the unit to your computer and to verify that it's
working.
The DS-DAC-10R operates on USB bus power. It does not need an AC adaptor or any
other external power supply.
Whenever possible, connect this unit directly to a USB port on your computer. If you
cannot avoid using a USB hub, you should use a USB hub that has its own power sup-
ply. A bus-powered USB hub may be unable to supply enough power.
1
If you want to listen through headphones, connect your headphones to the headphone
jack.
2
If you want to connect an amp and speakers for listening, connect the line out jacks of
the DS-DAC-10R to your system using the appropriate cables.
3
If you want to record, connect the output cable of your analog device to the line input/
phono jacks.

Operation

Headphones jack
8
Line output jacks
USB port
Line input/Phono jacks
Phono
ground terminal