Felton Designer Installation Manual

Slide showers

Slide Rail Installation

Carefully remove cover buttons from the mounting

brackets with a screwdriver as shown.

Select a location for the slide rail which is easily

reached and convenient for the user(s), preferably

over a wall stud or nog.

Using a level and the rail as a guide, mark and pre-drill

top and bottom mounting holes.

(If installing into wallboard or concrete, use toggles

provided by pre-drilling both top and bottom mounting

holes to 9.5mm diameter. Squeeze to close each

toggle and push in until flush with the wall).

INSTALLATION GUIDE

Designer Slide Showers

Fit the soap dish and slider onto the rail, sliding down

from the top of the rail as shown.

Fit the cover buttons back onto the mounting

brackets, taking care to match the lug on the cover

to the notch in the bracket.

Insert the screws provided through the mounting

brackets and into the pre-drilled holes. Tighten the

screws until the rail is firm against the wall.

Table of Contents

Do you have a question about the Designer and is the answer not in the manual?

Page 1 INSTALLATION GUIDE Designer Slide Showers Slide Rail Installation Carefully remove cover buttons from the mounting Fit the soap dish and slider onto the rail, sliding down brackets with a screwdriver as shown. from the top of the rail as shown.
Page 2 Warranty, Maintenance & Care - Designer Slide Showers Felton Industries Limited guarantees its products to be free from defects in materials and workmanship for a period of five (5) years from the date of purchase. This warranty is effective for 5 years from the date of purchase and covers supply of replacement parts only, not including installation.This warranty does not cover any damage to product due to abuse,...