Setting Valve Run Time - Toro LawnMaster 53603 Owner's Manual

Setting Valve Run Times
Follow the steps below to program how long each valve will water.
1. Set the dial to the Zone Run Time position.
2. Select program A, B, or C.
3. The display will indicate the valve number and then the run time for that valve.
4. Use the + and – buttons to change the time shown on the display.
5. Press the Next button to advance to the next valve.
6. Repeat steps 4 and 5 for each valve.
7. You may set the water duration for each zone from one minute to 9 hours and 59 minutes.
8. Set the watering time to under 1 minute or over 9 hours and 59 minutes to set the valve
in OFF mode.
Return dial to Run position.
Master Valve/Pump Start
A master valve or pump start is sometimes used in systems. When the master valve is on, the
timer provides constant output to that terminal when any valves are on. This feature allows a
pump to draw water from a well or other source, or opens the master valve whenever
watering occurs. The practice of using a pump is common in some areas and rare in others.
(If you do not have a pump start or master valve installed, you will not need this feature.)
The Lawn Master allows you to operate a master valve or pump start in each program.
5