OneHome
Manufacturer:
Model Number(s):
Comments:
Document Revision Date:
O
S
VERVIEW AND
UPPORTED
Sunfire receivers and preamp processors include an RS-232 or Ethernet connection which is used to
connect to the OneHome system and provide full two-way communications, enabling reliable control as
well as providing feedback to the OneHome system when changes (such as the current source or volume
levels) occur at the receiver.
S
UNFIRE DEVICES SUPPORT THE FOLLOWING FEATURES
Basic Source and Volume Control: Select any available source and control volume with two-way
feedback. Changes made at the receiver (turning the volume control, changing source) are immediately
reflected in the OneHome interface.
Multiple zones: Supported devices often have a second (or third, ...) zone, which can be controlled as its
own zone from the OneHome interface.
Onboard Tuner: Supported devices often include a built-in AM/FM tuner, which can play music in the
main or auxiliary zone. The tuner can be controlled from the standard AM/FM tuner interface in the
OneHome system.
RS-232 or Ethernet Control: Sunfire receivers and preamp processors have both a RS-232 port and an
Ethernet port on their back panel which are compatible with HomeLogic for control.
I
O
NSTALLATION
VERVIEW
1. During the rough-in phase install the necessary speaker and video cabling for the theater installation.
2. Also during the rough-in phase, run a Cat5 wire from the location of the receiver back to the Network
Assembly of the OneHome system to provide the communication connection needed to control the
receiver.
3. Install the speakers, display and other theater components.
4. Program the receiver according to the manufacturer's documentation.
5. Test the receiver to ensure that the sources play correctly and that the audio and video operate as
expected.
6. Connect the OneHome system to the receiver electrically. See the connection diagram and bill of
materials for more information. Refer to the RS-232 Connection Options Integration Note for other
serial connection options.
7. If using the Ethernet port for control, configure the receiver Ethernet settings. See Ethernet
Configuration below.
8. Configure the OneHome system for the device and confirm communication between the receiver and
the HomeBrick.
9. Test the system by changing sources and volume to confirm the correct source plays.
HomeLogic LLC
Sunfire
TGR-3, TGP-5
9/28/2007
F
EATURES
100 Hoods Lane
Marblehead, MA 09145
Receiver Integration Note
:
Phone (781) 639-5155
Fax (781) 639-9677