Removing A Blade - White Outdoor Z - 180, Z - 180L, Z - 200 Operator's Manual

Bracket
10. Repeat Step 7 and Step 8 for the other side of the mower deck.
11. From the rear, attach the belt around the Clutch Pulley.
12. Engage tension arm by moving it into the bracket to maintain belt tension.
13. Replace Belt Covers.
CUTTING BLADE CARE
WARNING:
blade with a rag to avoid injury.
Keep the cutting blade sharp and free of build up at all times:
• Sharpen ends of the blades evenly by keeping the same cutting angle to maintain balanced cutting blades.
• Remove debris build up from the underside of the mower deck housing using a putty knife.

REMOVING A BLADE

1. Secure the cutting blade by putting a piece of wood between the blade and the housing. (See Figure 28)
2. Use a 1-1/8 inch socket wrench on the pulley side of the spindle to secure.
3. Remove the hex nut using a 1-1/8 inch wrench.
J Pin
The cutting blades are sharp and can cause severe injury. Wrap the cutting surface of the
Figure 27
Figure 28
37
Lift Lever
Bracket