PUSHING YOUR UNIT
To push your unit you will have to first relieve the hydrostatic pumps. Follow steps 1 through 6.
WARNING:
wait until engine parts have cooled before disengaging.
1. Position the Z-series on a flat and level surface.
2. Engage the parking brake.
3. Remove the Hydraulic Relief Levers from the lock position. There is a lever for the right and left hydraulic
pump.
4. Slide the levers into the slots to relieve the hydraulic pumps. (See Figure 12)
5. Disengage parking brake.
6. Push unit.
The Hydraulic Relief Levers are near to engine parts that can be HOT. To avoid injury,
Relief Lever
(Right Relief Lever Shown)
Figure 12
17
Lock Position
Neutral Position