Advertisement
Flying-Boat: Assembly Instructions
Camber both wing tips
and
equally to the main wing.
Camber the wing tips carefully.
Dot towards the front.
According to the curve of the gluing position
for the main wing on the fuselage,
camber the main wing (
+
) evenly up
to both edges. Make sure that the dihedral
angle for the folded tabs are 10˚.
Camber the wing carefully.
10˚
Fold the tabs on
Dot towards the front.
Camber the wing tips carefully.
FINISHING TOUCHES
Give the finishing touches to the plane after it dries thoroughly.
Adjust the camber of both the main wing
and the wing tips carefully with your fingers.
Using the dihedral angle gauge, make sure
10˚
the dihedral angle for the main wing is 10˚.
through
.
Glue together
and
,
and
,
Using the engine installation lines and cuts on the main
wing as a guide, glue the four engines to the main wing.
Apply glue to the top surface of the folded tabs of the
main wing and attach wing tips
Before it dries, adjust the dihedral angles of
to 10˚. (Use the dihedral angle gauge.)
View the plane from both the front and the back
and straighten any warps or bends in the fuselage
and the wings.
- 3 -
and
,
and
to make four engines.
and
respectively.
and
Advertisement
