Led Ethernet Controller 3 (Lec 3) Device - LED Strip Studio LEC 3 Manual

LEC 3 - LED Ethernet Controller 3
LED Ethernet Controller 3 (LEC 3) is main controller for digital LEDs (pixels, strips, bulbs,
...). Using integrated DMX output, you can also use it to control analog lights (like strips,
pixels, PARs, ...). This provides you with convenient way to control all kind of LED lights
using one controller.
It integrates Ethernet, DMX and ArtNet controller and stand-alone player for digital lights.
It can control up to 4096 LEDs (4 outputs, each 1024 LEDs), but also it can send signal
to additional LSS Distributors. Additional LSS Distributors can be used to extend total
number of LEDs controlled by one LSS Ethernet to 8096 (distributors support up to
4000 LEDs).
Power
Maximal Number of LED
pixels to control
Connection
IP address range
LED Strip Outputs
SD-card
Supported IC
Firmware
LEC 3 device
4096 (8096 with additional Distributor)
Ethernet IPv4, DMX In / Out
Any (192.168.1.1-192.168.1.255 recommended)
4, each for up to 1024 RGB/768 RGBW LEDs
Up to 32GB, standard FAT32
TM, WS, APA (and more)
Upgradable
(we're adding support for new kind of LED IC chips)
5V, 0.5A
11