Download Print this page

AgSense Crop Link Wiring Instructions

2012 - 14 soil moisture monitoring
Hide thumbs Also See for Crop Link:

Advertisement

Quick Links

WIRING INSTRUCTIONS
2012 - 14
Crop Link
SOIL MOISTURE MONITORING

Advertisement

loading
Need help?

Need help?

Do you have a question about the Crop Link and is the answer not in the manual?

Questions and answers

Summary of Contents for AgSense Crop Link

  • Page 1 WIRING INSTRUCTIONS 2012 - 14 Crop Link SOIL MOISTURE MONITORING...
  • Page 2 Items Covered In This Manual: Page 1: Crop Link Device Overview Page 2: Connecting the Solar Panel Page 3: Connecting the Decagon 5TM, or 5TE, or MPS-2 Page 4: Connecting the Aqua-Check Soil Moisture Probe Page 5: Connecting the Sentek Soil Moisture Probe...
  • Page 3 General Overview of the Crop Link Unit Note: Once all sensors are connected and unit is ready to run, contact your AgSense Dealer to finish setup, and configure this unit to read the sensors that you have installed. Page 1...
  • Page 4 Wiring the Solar Panel to the Crop Link Unit Wiring the solar panel: Find the last two terminals on the large terminal strip labeled DC/SOL and GND 1. Connect the Black Wire (-) from the solar panel to the terminal marked GND as shown above.
  • Page 5 Page 2 Wiring the Decagon 5TM, 5TE, or MPS-2 Sensors to the Aqua Trac Unit Wiring the Decagon 5TM, 5TE, or MPS-2 sensor: Find the group of terminals (3) with the group label SDI. 1. Connect the Red wire from the Decagon Sensor to the terminal marked SIG as shown above.
  • Page 6 Page 3 Wiring the AquaCheck soil moisture probe to the Crop Link Unit Wiring the AquaCheck probe: Only 1 probe can be connected to this unit at a time. 1. Connect the Blue wire from the AquaCheck probe to the terminal marked SOIL as shown above.
  • Page 7 Page 4 Wiring the Sentek soil moisture probe to the Crop Link Unit Wiring the Sentek probe: Only 1 probe can be connected to this unit at a time. 1. Connect the Blue wire from the Sentek probe to any terminal marked SOIL as shown above.
  • Page 8 Open Circuit Voltage 21.2v DC Short Circuit Current 0.69A Warranty Information: All warranty service provided by the AgSense service center, or an authorized technician. Warranty repairs require a Return Merchandise Authorization Number (RMA); Have your dealer contact AgSense to obtain this RMA number.
  • Page 9 To know what your legal rights are, consult your local or state consumer affairs office or your state’s Attorney General. DISCLAIMER: The use of Field Commander/Crop Link/Aqua Trac shall not be utilized by customer as a substitute for the Customer's personal observation of the manner in which Customer's irrigation equipment is functioning.
  • Page 10 Link/Aqua Trac cannot solely replace the personal monitoring of the operation of irrigation equipment. REMEDY: Customer acknowledges that Field Commander/Crop Link/Aqua Trac’s sole obligation and Customer's exclusive remedy in the event of any material and continuing nonconformity, defect, or error in the information service shall be to take reasonable corrective actions upon discovery of the problem.