Advertisement
Quick Links
Advertisement
Related Manuals for AgSense Crop Link Lite
Summary of Contents for AgSense Crop Link Lite
- Page 1 WIRING INSTRUCTIONS 2017-18 Crop Link Lite/Pro TANK MONITORING...
- Page 2 Items Covered In This Manual: Page 1: Crop Link Device Overview Page 2: Connecting DC Power/Solar Panel Page 3: Connecting 120v AC Power Page 4: Connecting the Tank Monitor Sensor Page 5: Sensor Installation Tips Page 6-7: Submersible Tank Monitor Sensor Page 8-9: Specs and Warranty Information...
- Page 3 General Overview of the Crop Link Unit Note: Once all sensors are connected and unit is ready to run, contact your AgSense Dealer to finish setup, and configure this unit to read the sensors that you have installed. Page 1...
- Page 4 Wiring the DC Power or Solar Panel to the Crop Link Unit Wiring the solar panel or 7-30v DC power Source: Find the last two terminals on the large terminal strip labeled DC/SOL and GND 1. Connect the Black or Negative Wire (-) from the solar panel to the terminal marked GND as shown above.
- Page 5 If you are not using DC power or Solar Power: how to wire 120v AC to the Crop Link. 1. Connect 120v AC to the terminal marked 120v – units pre-wired with a cable from AgSense use a Black wire. Cable added by the customer should use the Black wire here.
- Page 6 Wiring the G3 Tank Monitor sensor to the Crop Link Unit 1. Connect the Red wire from the Tank Monitor Sensor to the terminal marked 12V OUT as shown above. 2. Connect the Black wire from the Tank Monitor Sensor to any terminal marked GND as shown above.
- Page 7 6. Caution - This transducer, while resembling our water pressure transducer, should NOT be used on a pivot. Doing so could result in the sensor being permanently damaged. Remember to Configure the Tank Monitor Sensor on the AgSense Website when installation is complete. Page 5...
- Page 8 Submersible Tank Level Sensor Wiring: Ashcroft KM45 series 1. Install the White wire into the 12v Out terminal as shown above. 2. Install the Brown wire into the GND terminal as shown above 3. Install the Yellow wire into any input (AN1 to AN4) terminal as shown above. 4.
- Page 9 Submersible Tank Level Sensor Wiring: Ashcroft SL17 series 4-20mA sensor 1. Install the Red wire into the 12v Out terminal as shown above. 2. Install the Green and Bare wires into the GND terminal as shown above 3. Install the Black wire into input AN5 4-20mA or AN6 4-20mA terminal as shown above. 4.
- Page 10 Open Circuit Voltage 21.2v DC Short Circuit Current 0.69A Warranty Information: All warranty service provided by the AgSense service center, or an authorized technician. Warranty repairs require a Return Merchandise Authorization Number (RMA); Have your dealer contact AgSense to obtain this RMA number.
- Page 11 Commander/Crop Link/Aqua Trac relies upon GPS, Satellite and Internet technology which not always functions properly, accordingly, AgSense disclaims any and all responsibility for the reliability of this technology. Customer acknowledges that AgSense does not have the ability to control the reliability of GPS, Satellite and Internet Technology. AgSense specifically disclaims any and all liability for Customer's failure to personally determine whether or not the irrigation equipment that belongs to Customer is functioning properly.
- Page 12 AgSense, LLC 259 Dakota Ave S PO Box 53 Huron, SD 57350 605-352-8350 www.AgSense.net...
Need help?
Do you have a question about the Crop Link Lite and is the answer not in the manual?
Questions and answers