Operating Your Washer - Whirlpool LMR4232A Use And Care Manual

Operating Your Washer
I
In This Section
Paw I
Bdors l
tarttng your washer
-5 ............................. .
Selecting a cycle Md time ............................. .6
Starting or atopping your waoher .................... .5 king
rinse and spin ....................................... 9
Sehctlng a wash temparaturo ........................... 5
Uolng drain and spin ....................................... 9
S&cling
a load 8izs .......................................... 6
What happens in each cycle .......................... .9
Operating your washer properly assures maximum washing efficiency. This section gives you
important information to help you to select a cycle, time, and temperature for your wash load.
Before starting your washer
Add measured detergent. Then place a sorted
See page 11 for additional "Before you wash"
load in the washer before starting.
information.
Starting or stopping your washer
Starting your washer:
1. Push in the Cycle Control Knob and turn it
clockwise. Stop when the indicator on the
knob's outer ring points to the number and
wash water temperature in the cycle you
want. The numbers are minutes of wash
time. Wash water temperature is indicated
by the letter near "fill".
2. Pull out the Cycle Control Knob.
Stopping and restarting your washer:
l
To stop the washer at any time, push in the
Cycle Control Knob.
l
To restart the washer, close the lid (if neces-
sary) and pull out the Cycle Control Knob.
Selecting a wash temperature
Match the wash water temperature to the type
of fabric and soils being washed. All rinses are
cold.
For hot wash water, turn the Cycle Control
Knob to Heavy, 14 minutes wash time.
For warm wash water, turn the Cycle Control
Knob to Normal, 10 minutes wash time; or
Delicate, 6 minutes wash time.
For cold wash water, turn the Cycle Control
Knob to Light, 6 minutes wash time.