Battery; Sounds Output; Cleaning; Transport And Storage - Cardionics E-Scope II Operator's Manual

shuts off power after approximately 1.5 to 2 minutes. The timer is
restarted each time one of the switches is pressed.

3.4 Battery

A single AAA battery powers the E-Scope. This battery will operate
the E-Scope for approximately 4.5 months assuming it is used 30
times per day, 5 days per week.
To change the battery, remove the battery cover by sliding it outward.
Remove the old battery and install the new in the normal manner.
3.5 Sounds Output. This connector, located on the body of the E-
Scope, allows accessory units to be attached to the E-Scope. See
Figure 12.

4.0 Cleaning

The E-Scope can be cleaned using a standard alcohol swab or wipe
(70% Isopropyl Alcohol). Do not use excessive liquid or immerse any
part of the E-Scope. Doing so may result in moisture getting inside
the unit.

5.0 Transport and Storage

The E-Scope can be safely stored or transported with the following
environmental conditions:
relative humidity.
-20°C – 65°C (-4°F – 149°F), <95%
10