Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for VOH WHEELTEST II
Summary of Contents for VOH WHEELTEST II
- Page 1 WHEELTEST II User’s manual Translated from french...
-
Page 2: Table Of Contents
Mecatronic solution EN_Wheeltest2_guide _V1.1 Created 24.02.2010 Page 2 User’s manual General information ............................3 Warranty ..............................3 Safety information ............................. 4 Transportation ............................4 Storage ..............................4 Parts of the machine ............................5 Principle of operation ..........................5 Use ................................... 6 Start-up .............................. -
Page 3: General Information
If at any time during the length of the warranty, the product shall be deemed faulty or break down, VOH Ltd. shall repair or replace it (choice to be made by VOH Ltd.). -
Page 4: Safety Information
Mecatronic solution EN_Wheeltest2_guide _V1.1 Created 24.02.2010 Page 4 User’s manual 1.2 Safety information Warning Do not use the Wheeltest 2 if it is damaged. Before using the Wheeltest 2, inspect its casing and its electrical connections. The Wheeltest 2 must be used in the way specified by the manufacturer. ... -
Page 5: Parts Of The Machine
Mecatronic solution EN_Wheeltest2_guide _V1.1 Created 24.02.2010 Page 5 User’s manual 2 Parts of the machine The Wheeltest 2 comprises a series of control knobs for the motor, two spindles to hold the wheel and a bow to drive it. Spindle blocks Spindles Motor 5V connection + switch... -
Page 6: Use
Mecatronic solution EN_Wheeltest2_guide _V1.1 Created 24.02.2010 Page 6 User’s manual 3 Use 3.1 Start-up The machine is started by the slide switch next to the power connection. When it is turned on, the motor will not turn, but the last parameters used (speed and direction of rotation) will be restored. 3.2 Use 3.2.1 Placing the component on the Wheeltest 2 The component to be measured must be placed in the Wheeltest 2 spindles and be slightly constrained between... -
Page 7: Changing Wheels
Mecatronic solution EN_Wheeltest2_guide _V1.1 Created 24.02.2010 Page 7 User’s manual To ensure play-free movement, the wheel must be slightly constrained between the two spindles. This constraint is guaranteed by a spring acting on the left spindle. While holding the left spindle in place, the blocking device for the left spindle must be separated, along the axis of the spindle, and its screw tightened in this position. -
Page 8: Resolution Of Common Problems
Mecatronic solution EN_Wheeltest2_guide _V1.1 Created 24.02.2010 Page 8 User’s manual 4 Resolution of common problems Type of error Cause Resolution Increase speed to confirm that the No LED turns on Speed was set at minimum during Wheeltest 2 is being supplied with when powered up last use power... -
Page 9: Representation/Distribution
Mecatronic solution EN_Wheeltest2_guide _V1.1 Created 24.02.2010 Page 9 User’s manual 8 Representation/distribution...
Need help?
Do you have a question about the WHEELTEST II and is the answer not in the manual?
Questions and answers