1. Manuals
  2. Brands
  3. VOH Manuals
  4. Test Equipment
  5. EBATEST
  6. User manual

VOH EBATEST User Manual

Hide thumbs
Table of Contents

Advertisement

Quick Links

Download this manual
EBATEST
User guide
Translated from french

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the EBATEST and is the answer not in the manual?

Questions and answers

Related Manuals for VOH EBATEST

Summary of Contents for VOH EBATEST

  • Page 1 EBATEST User guide Translated from french...

  • Page 2: Table Of Contents

    Solution mécatronique Ebatest Page 2 User guide General ................................. 3 Warranty ..............................3 Information ..............................4 Transportation ............................4 Storage ..............................4 Elements of the device ..........................5 Operation ..............................6 Switch on/off ............................... 7 Use ................................8 Settings ..............................10 Change the tip ............................

  • Page 3: General

    If the product is defective, call the VOH after-sales service +41 (32) 945 17 45. This does not apply if VOH SA shows that the defect or malfunction was caused by damages which occurred while the product was in possession of a buyer.

  • Page 4: Information

    1.4 Storage The Ebatest must be stored in a dry place and protected from dust. The storage temperature should be between 10° and 40° C (104°F). It is advisable pack the camera to protect it from dust and humidity.

  • Page 5: Elements Of The Device

    The handle is to move the tip downward (see chap. 3). The mirror enables the operator to place easily movement-holder on the Ebatest. The lever allows to free the counter-tip when the operator wants to change it. Micro Vision display :...

  • Page 6: Operation

    User guide 3 Operation The Ebatest allows the measurement of the shake on mounted watch-movements. Its accuracy is about one micron. Its operating principle is as follows: when moving down the handle, the counter-tip (lower tip) moves up and pushes the movement wheel from below so as to catch it in the slot. While continuing to descend the handle the upper tip comes pressing on the wheel from above.

  • Page 7: Switch On/Off

    Solution mécatronique Ebatest Page 7 User guide 4 Switch on/off Before switching on the display, make the following connections : Switch ON/OFF Feeler Power cable 230 VAC Sensor Once the connections are done, the display can be started by pressing the switch on ON. In the same way, it can...

  • Page 8: Use

    2. Place the watch-movement you want to measure on the fitting. 3. Place the movement on the Ebatest. The mirror allows to easily set the correct fitting hole on the pin (each hole corresponds to a wheel position on the movement and is specific to this movement).
  • Page 9 Solution mécatronique Ebatest Page 9 User guide 4. Lower the handle until the tip presses on the wheel. 5. Note dowb the value of the shake displayed on the Micro Vision.

  • Page 10: Settings

    Solution mécatronique Ebatest Page 10 User guide 6 Settings 6.1 Change the tip Tip : To change the tip, simply slide it by the top Caution : The head of the tip is extremely fragile !!! Avoid shocks, as it may damage it !!! Counter-tip : To release the counter-tip, remove the mirror and turn the lever.

  • Page 11: Representation/Distribution

    Solution mécatronique Ebatest Page 11 User guide 7 Representation/distribution...

Table of Contents