Electra Roman Blinds How To Install, Programme And Operate page 7

Power up & testing- blind supplied without a control
New blind - Existing Remote control/wall switch
Before you begin
The following instructions are relevant if you already have a remote control/wall switch and selected 'no control needed'
when ordering your Electra blind. The blind supplied has been set up with the up and down stop position preset for your
convenience.
Pairing your remote control/wall switch to your blind
STEP 1: Initiate programming.
Press both up and down
buttons together briefly and
let go - the blind will "jiggle".
A jiggle is a brief up and down
motion .
Electra Top Tip!
If you have a 5 channel
handset, make sure
you select the channel
the blind is to operate
in before pressing the
program button.
STEP 2: Pair the control. Press
and hold the programming
button* on the back of the
your handset or wall switch
until the blind jiggles. Your
control is now paired to the
blind motor.
*How to locate the programming button on your
control:
Single
channel
and 5-
channel
remote
Wall
switch
7