About The Ice And Water Dispenser - GE PFMS5RK Owner's Manual

Table of Contents

Advertisement

Available languages

Available languages

About the ice and water dispenser.

Spill Shelf
Dispenser Cradle
Spill Shelf
Important Facts About Your Dispenser
Do not add ice from trays or bags to
the storage drawer. It may not crush or dispense well.
Avoid overfilling glass with ice and use
of narrow glasses. Backed-up ice can jam the chute or cause
the door in the chute to freeze shut. If ice is blocking the
chute, poke it through with a wooden spoon.
Beverages and foods should not be quick-chilled in the ice
storage drawer. Cans, bottles or food packages in the
storage drawer may cause the icemaker or auger to jam.
To keep dispensed ice from missing the glass, put the glass
close to, but not touching, the dispenser opening.
To Use the External Dispenser (on some models)
Select CUBED ICE
,CRUSHED ICE
Press the glass gently against the top of the
dispenser cradle.
The spill shelf is not self-draining. To reduce water
spotting, the shelf and its grille should be cleaned
regularly.
If no water is dispensed when the refrigerator is
first installed, there may be air in the water line
system. Press the dispenser arm for at least two
minutes to remove trapped air from the water
line and to fill the water system. To flush out
impurities in the water line, throw away the first
six glassfuls of water.
CAUTION: Never put fingers or any other
objects into the ice crusher discharge opening.
Locking the Dispenser
Press the Lock Controls pad for 3 seconds to lock the dispenser and
control panel. To unlock, press and hold the pad again for 3 seconds.
To Use the Internal Water Dispenser
The water dispenser is located on the left wall inside the
refrigerator compartment.
To dispense water:
Hold the glass against the recess.
Push the water dispenser button.
Hold the glass underneath the dispenser for 2–3
seconds after releasing the dispenser button. Water
may continue to dispense after the button is released.
To Use the External Water Dispenser
Press the glass gently against the top of the dispenser
cradle.
The spill shelf is not self-draining. To reduce water spotting,
the shelf should be cleaned regularly.
If no water is dispensed when the refrigerator is first
installed, there may be air in the water line system. Press
the dispenser arm and run 1
gallons to remove trapped
1
2
air from the water line and to fill the water system. To
flush out impurities in the water line, throw away the first
six glassfuls of water.
(on some models)
or WATER.
(on some models)
If no water is dispensed when the refrigerator is first
installed, there may be air in the water line system. Press the
dispenser button for at least 2 minutes to remove trapped
air from the water line and to fill the water system. During
this process, the dispenser noise may be loud as the air is
purged from the water line system. To flush out impurities in
the water line, throw away the first 6 glassfuls of water.
NOTE: To avoid water deposits, the dispenser should be
cleaned periodically by wiping with a clean cloth or
sponge.
(on some models)
Locking the Dispenser
Press the LOCK pad for 3 seconds to lock the dispenser
and control panel. To unlock, press and hold the pad
again for 3 seconds.
Door Alarm
To set the alarm, press the DOOR ALARM pad. The indicator
light will illuminate. This alarm will sound if either door is
open for more than 2 minutes. The beeping stops when you
close the door.
Some crushed ice may be dispensed
even though you selected CUBED ICE. This happens
occasionally when a few cubes accidentally get directed to
the crusher.
After crushed ice is dispensed, some water may drip from
the chute.
Sometimes a small mound of snow will form on the door in
the ice chute. This condition is normal and usually occurs
when you have dispensed crushed ice repeatedly. The snow
will eventually evaporate.
Dispenser Light
This pad turns the night light in
the dispenser on and off. The
light also comes on when the
dispenser cradle is pressed. If
this light burns out, it should be
replaced with a 6 watt 12V
maximum bulb.
Door Alarm
(on some models)
To set the alarm, press this pad
until the indicator light comes
on. This alarm will sound if
either door is open for more
than 3 minutes. The light goes
out and the beeping stops
when you close the door.
13

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Pgms5rk

Table of Contents