Whirlpool W10026592A Use And Care Manual page 6

USING YOUR WASHER
S
TARTING YOUR WASHER
4.
Close the washer lid.
5.
Turn the Load Size selector to the correct setting
Medium
Small
Extra
Small
fabric care. See "Loading" later in this section.
•
Change the setting after the washer has started
filling by turning the selector to a different
setting.
6.
If a Soak or Prewash cycle is desired, set the
Warm
Cold
•
Select Cold (colors that bleed, light soils), Warm
(bright colors, moderate to light soils), or Hot
(whites and pastels, heavy or greasy soils) water.
7.
Select a Normal wash temperature or a Rinse
75
Cold
Cold
Cold
Your washer uses the ACCUWASH
ture control to regulate incoming hot and cold
water in the Normal wash cycle and Rinse and
Spin cycle (see the "ACCUWASH Temperature
Control System" section).
6
( CONT
for your wash load and
the type of fabric being
Large
washed.
•
Your washer has 5
Super
load size settings.
Plus
•
Choose a load size
that allows the load
to move freely for best
Soak/PreWash
Temperature selector
Hot
to the water tempera-
ture that matches the
type of fabrics and
soils in your load.
•
Follow garment
label instructions.
and Spin temperature
75
with the
75
Normal/Rinse and
100
Spin Temperature
Cold
selector. Match the
water temperature
with the type of fabrics
and soils in your load.
*
tempera-
.
)
8.
Turn the Fabric/Speed Select to the setting that
Perm Press Delicates
High
Low
Cotton
High
High
fabrics: Cotton, Permanent Press, Delicates and
Handwashables.
•
The selections will provide different agitation
and spin speeds.
9.
Push in the Cycle Control knob and turn it to the
10.
Pull out the Cycle Control knob to start the washer.
matches the type of
fabric in your load. See
Low
Low
the "Selecting a Fabric
Handwashables
Speed and Cycle
Intermittent
Low
Time" section.
•
The selector lets you
customize your wash
cycles for 4 types of
wash cycle you want.
See the "Selecting a
Fabric Speed and Cycle
Time" section.
•
Reduce the wash time
when using a small load
size setting.
NOTE: To stop the
washer at any time, push
in the Cycle Control knob.
To restart the washer,
close the lid (if open) and
pull out the Cycle Control
knob.