Advertisement
Quick Links
Pressure gauges
Type series BAxxxx, BBxxxx, BDxxxx, BHxxxx
Operating Instructions
1 General Information....................................................................................................... 2
1.1 General Safety Notes .............................................................................................. 2
1.2 Intended Use ........................................................................................................... 2
1.3 Conformity with EU Regulations .............................................................................. 2
1.4 ATEX Approval ........................................................................................................ 2
2 Transportation and Storage .......................................................................................... 2
3 Installation and Commissioning .................................................................................. 2
3.1 Mechanical Installation ............................................................................................ 3
4 Operation ........................................................................................................................ 4
4.1 Zero-point correction ............................................................................................... 4
4.2 Devices with Diaphragm Seal ................................................................................. 4
4.3 Maintenance / Service ............................................................................................. 4
5 Disassembly ................................................................................................................... 5
LABOM Mess- und Regeltechnik GmbH Im Gewerbepark 13 27798 Hude Germany
Hotline: +49 4408 804-444 Fax: +49 4408 804-100 e-mail: sales@labom.com www.labom.com
BA_008_2019-11_10.01
Page 1/5
Advertisement
Related Manuals for Labom BA Series
Summary of Contents for Labom BA Series
- Page 1 4.2 Devices with Diaphragm Seal ................. 4 4.3 Maintenance / Service ..................... 4 5 Disassembly ........................5 LABOM Mess- und Regeltechnik GmbH Im Gewerbepark 13 27798 Hude Germany BA_008_2019-11_10.01 Hotline: +49 4408 804-444 Fax: +49 4408 804-100 e-mail: sales@labom.com www.labom.com...
- Page 2 In addition to this instruction, be sure to observe all statutory requirements, appli- cable standards, the additional technical specifications on the accompanying data sheet (see www.labom.com) as well as the specifications indicated on the type plate. General Safety Notes The installation, set up, service or disassembly of this device must only be done by trained, qualified personnel using suitable equipment and authorized to do so.
- Page 3 Mechanical Installation Use gaskets, if required, that are suitable for the process connection and resistant to the media. Before starting operation, check the process connection carefully for leaks under pressure. Install safety pressure gauges in the line with DIN EN 837-1 S1 and S3 so that the exhaust equipment can freely discharge to the rear in the event of a fault or malfunction.
- Page 4 Figure 4: Zero-point correction adjustment pointer in the document TA_029 on www.labom.com. Devices with Diaphragm Seal Remove the protective cap or protective wrapping from the diaphragm only just before in- stallation to prevent contamination or damage.
- Page 5 Disassembly When measuring hot media, make sure that the device has cooled down prior to any dis- mounting or wear appropriate protective clothing to avoid burns. Warning Opening pressurized lines might cause severe injuries. Danger of severe injuries or damage ...