This product is designed for the supen- sion of a freely hanging load. Adapted for use in combination with Indexator’s H-rotators. The products brake unit is designed to reduce the oscillating action. The disc should be kept free of grease and oil to ensure the best braking effect.
3. Safety sticker The sticker should be positioned so that it is easily visible to the driver without hindering the view. The sticker is self-adhesive. The surface to which the sticker is attached must be thoroughly cleaned. 4. Assembly instructions for the lower brake For rotator and swing damper 4.1.1 Check that the bushings are correctly...
Page 4
4.3.3 The sleeves G, have to be greesed both in- and outside, and the tube H greesed ourside with copper paste or similar. 4.3.4 Assemble sleeves G from each direction and then feed into the centre pipe H to the centre. 4.3.5 Assemble the adjustment screws F.
Page 5
Secure the bolted joint with the locking nut after adjusting. 5.3.2 The pin in the crane nose is assembled in accordance with the crane manufacturer’s recommendations. Indexator recommends: Surface fineness Ra < 1,25 µm (50 µin) Surface hardness > 50 HRC...
6. Maintenance instructions Lubricate the link’s bearings every 50 hours. In order to achieve the best operating purpose possible the sleeves G should be greesed both in- and outside, and the tube H greesed outside with copper paste or similar every 1000 working hours.
Page 8
Indexator Rotator Systems Tel + 46 933 148 00 rotator@indexator.com www.indexator.com...