Advertisement
ASSEMBLY
•
Make sure the main fan body is secured tightly to the base with the thumbscrew
under the base .
•
Remove the four screws in the main body and reuse to attach the rear fan guard,
ensuring the handle is at the top.
•
Slide the fan onto the axle screw first and tighten the screw ensuring it is in contact
with the flattened edge of the axle.
•
Remove the bolt and nut from the bottom of the front guard and rotate all clips to
an open position.
•
Attach the front fan guard, lining up the top notch with the rear guard and ensuring
the bolt hole is aligned for the two halves.
•
Close the clips and replace the nut and bolt locking the two halves together.
OPERATION
•
Connect the power plug to a suitable outlet.
•
Oscillation: In order to make the fan oscillate, push down the oscillation knob.
To stop the fan head from oscillating, pull up the oscillation knob.
•
Select the desired speed using the speed control:
0 = device off
1 = Low speed
2 = Medium speed
3 = High speed
CLEANING & MAINTENANCE
•
Before cleaning, switch the fan off and unplug from the power supply.
•
To clean the fan, use a soft cloth to wipe off any dust. If the fan is very dirty, use a
damp cloth and wipe dry.
•
Do not use any chemicals, abrasives or solvents that could damage the fan.
•
Store the fan in its original packaging in a dry, well ventilated area.
•
The motor bearings are permanently sealed and do not require additional
lubrication.
TECHNICAL SPECIFICATION
INFORMATION ON WASTE DISPOSAL FOR CONSUMERS OF ELECTRICAL &
ELECTRONIC EQUIPMENT.
When this product has reached the end of its life it must be treated as Waste Electrical
& Electronic Equipment (WEEE). Any WEEE marked products must not be mixed with
general household waste, but kept separate for the treatment, recovery and recycling of the
materials used. Contact your local authority for details of recycling schemes in your area.
Power consumption
Main voltage
Dimensions
Weight
35W
220-240V~ 50Hz
340 x 240 x 420mm
3.0kg
Made in China. PR2 9PP
Man Rev 1.2
Advertisement
