Storing And Scrapping - LAUNCH TECH TWC-502RMB Manual

LAUNCH
position after locking.
If the horizontal arm can not be moved smoothly or
the clearance is too much after locking, do the
adjustment according to the following procedures:
l Open the protective cover of the tilting post.
Adjust the M6 screws at both ends by wrench and
l
push the arm at the same time until it can be
moved smoothly. Then tighten the nut.
Adjust the screw at middle by wrench and lock the
l
horizontal arm to see the change until the
clearance is satisfactory. Then tighten the nut.
Periodically clean the control valves for clamping
jaws and bead breaker to insure their normal
operation.
l Remove the side cover of the cabinet.
l Loosen the control valve muffler and air bleed
valve muffler, and clean them with compressed air.
(Fig.33)
Fig.33
Storing
Storing
When the equipment needs to be stored for a long time:
l Disconnect the power and compressed air.
Lubricate all the parts: slide block and groove on
l
the turntable.
Empty all the oil/liquid cups.
l
Cover the equipment with plastic shield.
l
Scrapping
When the equipment can no longer be used, disconnect
the power and compressed air and dispose in
accordance with the local regulations.
12
Tyre Changer (TWC-502RMB)